The Chrysler Minivan Fan Club Forums banner

Search results

1-4 of 4 Results
Advanced Search
  1. OTC Monitor 4000 help please

    1st Generation Chrysler Minivan: 1984-1990
    Would like some help from someone who has used a OTC Monitor 4000 Enhanced with Pathfinder II cartridge. Van is a 1988 3.0 Voyager. Scanner says "No data", which sorta fades in and out every second as if data is coming in though the scanner doesn't sync up with or recognize it. Any ideas what...
  2. No torque converter lockup

    1st Generation Chrysler Minivan: 1984-1990
    The issue was the distance speed sensor. It wasn't totally dead so it didn't set a code. It was putting out 3 pulses per revolution instead of 8. I didn't think of checking if the cruise control still worked at low mph, like 35. [email protected] If you don't have a ohm meter a little trick is to hold...
  3. Stuck in diagnostic mode? / No start

    1st Generation Chrysler Minivan: 1984-1990
    1988 Voyager 3.0 135k I was tinkering trying to get an old scanner to connect, doing key off-on-off-on-off-off. I got no connection so I turned the key off and disconnected the scanner. Cranked the engine and it fired a bit then died. This repeated over and over. I took a 1 hour break, tried...
  4. No torque converter lockup

    1st Generation Chrysler Minivan: 1984-1990
    1988 3.0l Voyager, 135k. Transmission shifts fine but does not lockup the torque converter. I have the factory manuals but it is not much help regarding the computer control of the lockup solenoid. What are some causes of the computer not locking up the converter? I know a bad speed sensor is...
1-4 of 4 Results
Top